Dryer Repair across Northeast Georgia
Our EPA-certified, licensed technicians repair dryer across Northeast Georgia — flat-rate pricing and a 3-month parts & labor warranty, often the same day.
EPA-Certified Tech On Call
Dryer problems we repair
Gas and electric dryers, vented and condenser. Several of these faults are also a fire-safety issue, so we restore safe airflow as part of the repair.
Not heating
The drum turns but clothes stay damp or cold. On electric units it is usually the heating element, thermal fuse, or thermostat; on gas, the igniter or gas valve.
Won't tumble
The drum will not turn. Typically a broken drive belt, a seized idler pulley, or a failed motor.
Takes too long to dry
Weak airflow from a clogged lint filter, a blocked vent, or a long restricted duct run. We clean the full path and restore airflow.
Overheats or shuts off
Restricted venting or a failing cycling thermostat trips the safety. We find why it is overheating, not just reset it.
Noisy — squeal or thump
Worn drum rollers, glide bearings, the idler pulley, or a worn belt. We replace the worn parts and the noise goes away.
Won't start
A dead dryer usually comes down to the door switch, thermal fuse, start switch, or control board.
Vent or duct blockage
Lint buildup is the leading cause of dryer fires. We clear the duct, cut dry time, and improve safety.
Error codes or controls
A blank panel or fault code. We read the code and trace it to the sensor or control board.
Don't see your symptom? Call (770) 601-4241 — our dispatcher will triage in under 60 seconds.
Which dryer type do you have?
Gas or electric, vented or ventless, full-size or stacked — we service every configuration and bring the right parts for yours.
Electric Dryer
Plugs into a 240V outlet. Common: heating element, thermal fuse, thermostat, drum rollers.
Gas Dryer
Natural gas or propane burner. Common: igniter, flame sensor, gas-valve coils, thermal fuse. Gas-certified work.
Vented
Exhausts hot, moist air outdoors. Common: clogged vent run, blower wheel, and lint-trap housing.
Ventless / Heat-Pump
Condenses moisture internally. Common: condenser coil, drain pump, sensor, and refrigerant-side faults.
Stacked / Laundry Center
Sits atop the washer or in one tower. Common: belt, drum glides — plus the tight access we're equipped for.
Compact / Portable
24-inch or 120V units. Common: thermal fuse, heater, and door-switch wear from frequent use.
Brands we service
Factory-authorized on Tier 1 premium, certified across every mainstream brand. We carry common failure parts for the top 12 brands on every van.
Premium & built-in
Mainstream & smart appliances
Serving homes & businesses nearby
We cover 14 cities across the Gwinnett, Barrow and Athens area. Residential and commercial — same flat-rate pricing, same 3-month warranty.
Service area
Dryer repair questions
The questions our dispatcher hears most often.
Do you service gas and electric dryers?
Yes — both gas and electric, vented and condenser, across all major brands.
My dryer runs but takes forever to dry — what's wrong?
Almost always airflow: a clogged lint filter or a blocked vent duct. We clean the full run and confirm the heat and thermostat are working.
Is a clogged dryer vent really dangerous?
Yes. Lint is highly flammable and a restricted vent is a common cause of dryer fires. We recommend cleaning the vent at least once a year.
Should I repair or replace my dryer?
If the repair is under about half the cost of a new unit and yours is under roughly 8–10 years old, repair usually makes sense. We will be straight with you either way.
How long does a dryer repair take?
Most repairs are completed in one visit, around 45–90 minutes. Ordered parts typically arrive within 24–48 hours.
What does it cost and is the work guaranteed?
You get a flat-rate quote up front before any work begins, and every repair carries a 3-month parts & labor warranty.
Let's get your appliance working again.
One call, technician at your door today. We're open 7 days a week, real dispatcher answers in under 60 seconds.